4ft 18w T8 G13 LED Tube Light 65W Fluorescent equivalent - 25 Pack



This 48" ( 4ft) LED light tube is a replacement for standard fluorescent light tubes, the light is very bright and can be used as indoor and outdoor lighting and decorating. This is a direct "drop-in" replacement for standard fluorescent light tubes by just bypassing Ballast. It is compatible with virtually every standard ballast equipped fluorescent light fixture. For installing, simply by pass the existing ballast and connect the live (hot) wire to any one pin of an end and the neutral wire to the other end. This White bright LED lights consume 18w power and saves 60% power comparing with to the fluorescent light. Can be used for general lighting at your home or office.


  • Using imported high brightness LED as light source
  • Brightness is three times as the same power traditional light source
  • Low power consumption, in the same lighting effect, over 80% of energy saving than traditional light
  • High efficiency and no pollution, no ultraviolet ray and infrared ray in the LED tube spectrum and no radiation
  • Lifespan is more than 50,000 hours, 10 times more than traditional light source
  • Easy Install, Can be installed on the traditional T8 lamp-socket directly by bypassing ballast
  • Work normally in low voltage situation

Key Benefits:

  • Cut Energy Costs by 60-80%
  • Lamp Life: 50,000 hrs
  • Bright Light output
  • Mercury free, No Health Hazards

If any questions please contact us at support@usledmart.com or click here to submit request

Power: 18w
Size: 4ft [ 25.4mm(D)*1199mm(L) ]
Material: Glass + PC/ABS
Color Temperature: 6500K / 5000K ( Select from the drop down )
Lumens: 85 lm/W (1530 Lumens in Total )
Power factor: >0.90
Base Type: G13/Bi Pin
Weight: 205g - 265g
Application: Office, Room, Super Market, School, Factory, Warehouse, Workshop, Gas Station, Residential
CRI 80
PC Cover Frosted Cover
Voltage: AC 100-240V
Warranty: 30 Day Money Back
Lifespan: ≥35,000 hrs
Light Source SMD2835
Beam Angle 270 Degree
Certification CE & RoHs& IEC


Easy Installation:

1. Remove Fluorescent Tube

2. Remove the Ballast/Starter or by pass

3. Open\Remove Wiring Compartment Cover

4. Connect the wires as shown in the Installation manual ( Bypass Ballast & Starter )

Color Temperature: Available 5000K and 6500K ( Choose from the drop down )